OneUp Components Aluminium Pedals 9/16″ Pedal Flat Platform MTB Mountain Bike DH

The OneUp Components Aluminium Pedals features a huge (115x105mm) super grippy platform with 10 rear-loading hexagonal steel pins per side to keep your feet planted on even the roughest of trails. With a weight of only 386g, they wont slow you down on the climbs.

Designed from stealth rubber down and shaped with a subtle convex profile to therefore provide you with more grip thanks to the pedals sitting in the natural arch of your foot. The ultra-thin design (only 8mm at the leading edge) gives you maximum clearance to significantly reduce pedal strikes and deflect off trail obstacle. Clip Less, Ride More.

When its finally time to service your bearings, the unique cassette tool lock ring system makes re-greasing the bearings exceptionally fast and easy.

FEATURES:

• 10 rear loading custom hexagonal removable pins per side for maximum grip.
• Ultra thin leading edge chamfered design to deflect off generally any obstacle.
• Fully sealed and serviceable design with built in bearing extractor.
• Wide platform design for significantly increased stability.
• Contoured shape provides the ultimate connected feel.

SPECS:

• Weight:386g.
• Platform Size:115x105mm.
• # of Pins:10 per side.
• Axle Material:Chromoly steel.
• Height:8.3-12mm.
• Pin to Axle distance:112mm.
• Colour:Black, Green, Grey, Red, Orange, Blue, Purple and Oil Slick.
• Body Material:6061-T6 Aluminum.

COMPATIBILITY:

• Currently, due to the specifically deep counterbore of the crank arms, these pedals are not compatible with SRAM Carbon cranks.
• These pedals are not compatible with crank boots without modification to the crank boots. We recommend removing crank boots before installation.

INSTRUCTIONS:

• Ensure flange pedal washer and lip seal are assembled with flange side towards crank. In the following orientation.
• Install with 8mm Hex. Torque to 35Nm (25 ft-lbs) Min.

NOTES:

• Uninstalled pedals have a minimal axial movement built in that is eliminated when fully install on cranks.
• The retaining O-ring is only to keep the flange washer and seal on the pedal in the box and for assembly. It is not necessary for the function of the pedal and can be removed.
• Out of the box our pedals have some resistance to free spinning by design. This can be adjusted by adding or removing grease upon disassembly. Free spinning will increase over time and wear of the bushing.
• These pedals are not compatible with crank boots without modification to the crank boots. Accordingly we recommend removing crank boots before installation.